EZ Handrail EZG106 Bedienerhandbuch PDF herunterladen (Seite 11)

Installing the Lower Assembly

STEP 1:

1. Attach Mid Support (K) underneath the Bottom Assembly t the midpoint of the

railing section (Illustration 3B).

2. Place the Bottom Post Mounts (D) on each end of the Bottom Channel Assembly

making sure the fastener portion is facing up. (Illustration #4).

3. Attach the Bottom Channel Assembly to your post. (The maximum distance from

the decking / flooring to the bottom of the Bottom Glass Channel Assembly is 3

3/4.”(Illustration #4).

4. Suggestion: The width of a 2x4 is 3 1/2,” some contractors will install the

Bottom Channel Assembly by setting it on 2x4’s at both ends.

5. Fasten the Bottom Channel Assembly Post Mounts (D) to the post using the

appropriate fasteners (J, M, N). (See post detail page if necessary).

6. Secure a third fastener (J) through the side of the Top Post Mount (E) securing

the Bottom Channel Assembly to the Bottom Post Mount. This fastener should

be placed on the outside (non viewable side) of the railing as indicated below.

Repeat at the opposite end.

Illustration #3B

Illustration #4

Spacing is not to exceed 3 ¾” from

the bottom of the channel to the

deck.

(D)

(J)

Midfoot (K)

www.ezhandrail.com for videos 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Keine Kommentare

EZ Handrail EZG106 Bedienerhandbuch Seite 11